Remove the protective covers without damaging the bicycle. Mount the front wheel. Pre-assemble the stem and front wheel. Install the front mudguard. Fit the front mudguard and tighten it with a 10 mm wrench. Finish the assembly by removing the front wheel bolts to secure the mudguard legs. Replace the bolts and tighten the wheel with a 15mm wrench. Remove the pedals from their packaging and identify the pedals
Left=L Mount the saddle on the seat post by tightening the screws on both sides. Mount the saddle on the frame Align the cockpit to the front wheel Then gently bend the stem and tighten the screw with a 6mm Allen key. Check the stem closing system, a certain tension must be felt on the lever. If necessary, increase this tension by tightening this screw with a 10 Attention: Never forget the plastic security lock! Check central clamping To open the system, lift the quick release up and fold the bike. If the closure is too loose, turn the quick-release clockwise to increase the tension. Line up the brake pads on the rim. Place the metal ball of the cable into the brake lever. Stretch the brake cable and tighten it with a 5mm Allen key. Use a 5mm Allen key to mount the brake lever Use a screwdriver to screw the bell on. Put on the reflectors.